arma 3 task force radio not working for remote control

(Please keep this volume to normal unless told otherwise by a Squad leader or superior).ĬTRL + ALT + ] Select next long range radio.ĬTRL + ALT + [ Select previous long range radio.ĬTRL + Change personal radio stereo mode.ĪLT + Change long range radio stereo mode. Does not affect the signal volume in the radio transmission.

You can talk: Whispering, Normal or Yelling. Also it is possible to load radio settings from another radio with same encryption code.ĬTRL + ALT + Cycle through available long range radios.ĪLT + Up/Left/Right Arrow Rapid switching of long range stereo mode.ĬTRL + NUM Rapid switching of long range radio channels.ĬTRL + TAB To change the direct speech volume. Besides, one of them can be set as active. If a number of radios are available – you'll be offered to choose one. NUM Rapid switching of shortwave radio channels.ĪLT + P To open a long range radio interface (a long range radio must be put on your back, or you should be in a vehicle in a position of a driver, shooter, or pilot assistant). Also it is possible to load radio settings from another radio with same encryption code.ĬTRL + + Cycle through available shortwave radios.ĬTRL + Up/Left/Right Arrow Rapid switching of shortwave stereo mode. It is also possible to set the radio as active (the one that will be used for transmission). In that case if you have a number of radios - you can select the one needed. Push-to-talk button in TeamSpeak Direct Speech.ĬTRL + Caps Lock To talk on a long range radio.ĬTRL + P To open the personal radio interface (the radio must be in the inventory slot).

This guide hopefully serves as an introduction to the control, keys and usage of TFAR - which is the Radio system plugin for Teamspeak which we use to communicate in game.

A condensed guide in one place is better for all. Over time more sections on additions via ACE and other mods have been added. I added the information about additional channels and how to use them as well as the images for illustration purposes. Most of this information can be found (and was taken from) Task Force Radio's website. Since I am aiming this guide at people who are new to TFAR, I am assuming that no keybinds have been altered. If you have then you will need to refer to the rebound keys rather than the basic config. This guide assumes you have not changed any settings or key binds.

Arma 3 task force radio not working for remote control